목록
이전글
다음글
CS - 8000
Semiconductor Curve Tracer CS-8000 Series
Up to 5kV, 2000A High-Power Test
■ Accurate very small current Measurement (resolution 250fA）
■ Large 12.1-inch Touch Screen
■ Variety of GATE Signal Output
■ Enhanced Temperature Characteristic Measurement Option
■ On-Wafer High-Power Testing with Wafer-Prober
■ Accurate very small current Measurement (resolution 250fA）
■ Large 12.1-inch Touch Screen
■ Variety of GATE Signal Output
■ Enhanced Temperature Characteristic Measurement Option
■ On-Wafer High-Power Testing with Wafer-Prober
카탈로그 다운
CS - 8020 : 200V
CS - 8200 : 2000V
CS - 8500 : 5000V
CS - 8200 : 2000V
CS - 8500 : 5000V
(1) X-Y Display Window
The voltage/current parameter can be set on the X-axis Y-axis, and a variety of semiconductor characteristic curves such as Vds-Id characteristics, threshold voltage,
The voltage/current parameter can be set on the X-axis Y-axis, and a variety of semiconductor characteristic curves such as Vds-Id characteristics, threshold voltage,
and Vds-Vgs saturation characteristics can be displayed. Also several parameters can be set on the Y axis. The scale can be selected from Log or Linear.
(2) Y-T Display Window
The measured applied waveform is displayed on the time axis like an oscilloscope. It is easy to verify if accurate measurements have been operated because the CS-8000 series can show the pulse width, the measurement point and the abnormal waveform such as an oscillation in real time. All applied waveform data and the data on the X-Y display are saved at the same time. So the measurement result can be re-validated.
(3) Measurement Data Display Window
This window shows detailed measurement information such as results and conditions, status in text format.
(2) Y-T Display Window
The measured applied waveform is displayed on the time axis like an oscilloscope. It is easy to verify if accurate measurements have been operated because the CS-8000 series can show the pulse width, the measurement point and the abnormal waveform such as an oscillation in real time. All applied waveform data and the data on the X-Y display are saved at the same time. So the measurement result can be re-validated.
(3) Measurement Data Display Window
This window shows detailed measurement information such as results and conditions, status in text format.
The X-Y, Y-T, and measurement data display areas can be toggled on/off and resized depending on the masurement. Also these three areas are linked together.
(4) Configuration Setting Window
In this window, the measurement configuration for the device is set. It supports the selection of voltage/current units, wiring changes, etc. in a graphical display.
(5) Parameter Setting Window
This area is where you set measurement parameters, measurement limits, and switch between Manual/Auto measurements.
(6) USB Interface
Waveform images, data and setup conditions can be saved to the USB memory directly.
(7) Control Panel
DRAIN/COLLECTOR・GATE/BASE・vertical/horizontal axis rotary knob, buttons and rotary knobs are located on the front panel for easy manual measurements.
The central numeric keypad allows you to enter a numeric value for the parameter.